5 Inch 10 Inch 20 Inch Length Microfiltration Stainless Steel Filter Mesh

5 "10" 20"Length / Microfiltration / 222 226 M30 Connector Stainless Steel Filter Mesh

Product introduction

Stainless steel sintered mat filter element is mainly made of stainless steel fiber sintered mat and stainless steel braided net processed by folding process. Stainless steel fiber sintered mat can be made into a multi-layer structure with pore diameter from coarse to fine, with high porosity, high pollution carrying capacity and other characteristics.Stainless steel woven mesh is made of stainless steel wire of different diameters, made of filter element has good strength, not easy to fall off, easy to clean, high temperature resistance, economic use and other characteristics.

Product features

• 1, stainless steel precision filter element with high porosity, good air permeability, small resistance, low use pressure difference;
• 2. After the stainless steel precision filter is folded, the filter area is large and the pollution is large;
• 3, Stainless steel precision filter element high temperature resistance, corrosion resistance, suitable for high viscous liquid filtration;
• 4, good regeneration performance, after chemical cleaning, high temperature and ultrasonic cleaning can be used repeatedly;
• 5, All stainless steel structure, wide chemical compatibility;

Product parameters

Cleaning method

• 1. Generally choose backwashing on the production line: first close the pipe switch of raw solution and filtrate, rinse with bacteria-free water, input from the original outlet, discharge from the inlet or the lower drain hole of the filter, backwashing should have pressure but not too large, generally about 5kg.
• 2. Remove the stainless steel folding filter element and put it in the cleaning solution for cleaning. First soak it in repeated cleaning.
• Cleaning fluid is generally available:
• A. Sodium hydroxide, 0.1 nNaOH
• B.1-2% citric acid solution or 0.1N oxalic acid solvent, 0.1N hydrochloric acid solvent.
• C. Enzyme solvents and other solvents are generally cleaned at a temperature of 30-40 degrees is the best.
• Precautions during cleaning: high protein content of filter solution, such as draft beer and nutrient solution, must be sterilized at high temperature after cleaning the filter element to prevent protein condensation at high temperature from blocking the membrane hole.

Factory introduction

Packaging logistics​